Assa Abloy DK-26 Manuale Utente Scaricare il pdf

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader

Tel 800.624.5625 [email protected]

in door opening solutions

Page 1 Rev. C, 08/11

SECURITRON MODEL DK-26W DIGITAL KEYPAD

INSTALLATION & OPERATING INSTRUCTIONS

1. DESCRIPTION

Securitron's DK-26W is a two piece digital keypad system designed to output Weigand 2601

format data and therefore integrate into an access control system just as if it was a card

reader. It consists of two components: the keypad and the CPU board connected by a 16 ft.

cable. The rugged stainless steel keypad may be mounted outdoors in any environment as it is

fully weatherproof. The keypad features two active LED’s (green and red controlled by the

system) and a beeper.

2. PHYSICAL INSTALLATION

The first step is to plan the physical location of the two components. The keypad is normally

surface mounted on the outside of the door to be controlled, and the CPU Board is mounted

inside the protected area safe from tampering.

FIG. 1: PHYSICAL INSTALLATION OF KEYPAD

MOUNTING

SURFACE

(1) MOUNT SCREW TO ENGAGE SLOT AT

TOP OF KEYPAD

DRILL 1/8" (3MM) HOLE

(2) DRILL 3/8" (10MM) HOLE FOR CABLE

(3) SECURE BOTTOM WITH SECOND

SCREW. COVER SCREW HEAD WITH

"DK-26" LABEL.

DRILL 1/8" (3MM) HOLE

NOTE: CHOOSE PHILIPS OR SPANNER

(TAMPER) HEAD SCREW

CABLE

To install the keypad, holes must be drilled for the 2 mounting screws and the cable. A template

is not provided due to unavoidable variations on the cable exit of each keypad. Referring to

Figure 1, note that the top screw engages the slot at the top of the keypad. Once the top screw

has been installed, the location of the cable hole should be set roughly by positioning the keypad

and marking the cable hole point. Make sure the keypad is pulled down firmly on to the screw.

A 3/8" (10MM) hole is then drilled for the cable. After the cable has been pulled through, the

final screw secures the keypad to the wall. Note that 2 alternate bottom screws are supplied

with the unit. One is a #10 spanner head for improved tamper resistance. Alternately the #8

Phillips standard screw may be used. After this, peel the backing of the enclosed Securitron DK-

26 label and affix it to the bottom of the keypad covering the head of the screw. This

not only improves the appearance of the keypad but helps foil casual vandalism. Note finally

that a blank rectangular label has also been furnished. This can be used to cover up the

“BELL” legend if desired.

The CPU Board is furnished in a snap-apart steel enclosure with the board itself mounted on

plastic snap-trak. The CPU Board must be installed in a dry location free of extremes of

temperature and humidity. If the 16 ft., twelve conductor cable that is included is not of

sufficient length, additional cabling can be spliced by the installer. However, a long cable run

1 2 3 4

department 4

Sommario

Pagina 1

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader Tel 800.624.5625 [email protected] in door opening solution

Pagina 2

PN# 500-12500 Page 2 Rev. C, 08/11 can give rise to electronic noise problems in certain environments. It should therefore be avoided where po

Pagina 3

PN# 500-12500 Page 3 Rev. C, 08/11 3.2 LED AND “TRANSMIT DATA” WIRING The LED’s on the DK-26W follow the convention for card readers. When a

Pagina 4 - department

PN# 500-12500 Page 4 Rev. C, 08/11 the unusual case where both keypads are being used simultaneously, the code will not be properly sent as the

Più documenti per Tastierini numerici Assa Abloy DK-26

Per vedere il documento Assa Abloy DK-26 Istruzioni per gli Interventi

Assa Abloy DK-26 Istruzioni per gli Interventi (23 pagine)

Per vedere il documento Assa Abloy DK-26 Specifiche

Assa Abloy DK-26 Specifiche (76 pagine)

Per vedere il documento Assa Abloy DK-26 Manuale Utente

Assa Abloy DK-26 Manuale Utente (2 pagine)

Assa Abloy DK-26 Specifiche (116 pagine)

Assa Abloy DK-26 Manuale Utente (4 pagine)

Commenti su questo manuale

Nessun commento

Assa Abloy DK-26 Manuale Utente

Navigare online o scaricare Manuale Utente per Tastierini numerici Assa Abloy DK-26. DK-26W Installation Instructions Manuale Utente

Sommario

Più documenti per Tastierini numerici Assa Abloy DK-26

Commenti su questo manuale

Prodotti e manuali riguardandi Tastierini numerici Assa Abloy DK-26